Alexandr A.Shpilman (alexandrshpilman78@gmail.com )
Converter-NQ3
As time
goes by, the design of "Converter" develops. On Photo 1,2 shows the Converter-NQ3. In contrast to the structures
described in the "Converter-NQ" new device operates in push-pull mode and has a much
greater active volume. Due to what is an order of magnitude more power.
|
Photo1 |
Fig.1 |
Photo2 |
Figure 1 shows a cross-sectional
design of the emitter. Where the aluminum tube 1, an iron reflector 4, two
ferrite rings 2,3 with electrical coils wound with
double wire Litz wires (copper electrical wire
insulation in the silk). Winding energized as shown in Fig.4 in the article
"Converter-NQ". But the phase of the
signal of the coils 2,3 are shifted relative to each
other by 180 degrees. This gives the efficiency of the Converter due to the
interaction between the fields generated by these coils.
Blue shows how is oriented the
magnetic vector potential 5. Also, "toroid"
odds generated by the instrument "axion
field" predominantly type 2. (See " Physical properties of axion
(spin) fields")
In "Some Effects" you can read
the experience of using the device.
|
You can buy the generator of the
described design Attention,
this generator is not a magic wand! Its
main destination - to carry out of researches. (Information on E-mail: alexandrshpilman78@gmail.com ) |